Shopsmith Ovararm Pin Router
Click here for a printer friendly version of Tip-
Pg. 1-4, Pg 5-8, Pg 9-12, Pg 13-16, Pg 17-20, Pg 21-23

Using A Drill Press Vise To Hold Workpieces

In some cases, you may have a workpiece that cannot be held properly for making cuts on a flat table surface or against a fence. An example of this could be cutting a mortise in a leg using a drill press vise (Figure 22-51).

To accomplish this task, make a sliding table to hold your vise like the one shown in Figure 22-52. Also use the fence extensions and stops (Figure 22-21) to control the length of the cut.

Continue to Under Table Operations
Back to Fluting